Strobel VTD410EV-SEPC1, Operating Instructions Manual

Page: 11 / 36

7
BA_VTD410EV-SEPC1_A1_140417_en
3 Installation and putting into service
3.1 Unpacking the machine
The machines of the series 400 are only supplied complete.
The thread stand, oil and other machine tool accessories located with in the
package.
Make sure that all accessories have been unpacked before throwing away any
packing material.
3.2 Installation
A T T E N T I O N !
Danger of bodily injuries or finger bruises through pulling in
of garments or hairs!
The machine may not be operated without belt guards for
head and motor.
The electrical connection must be carried out according to the marking of the
cable or the supplied wiring diagram.
Check if all screws on the stand are tight and retighten them, if necessary.
Before putting the machine into service make sure that the electrical connecting
data on the motor's name plate, your electric network and the frequency, and all
other connecting values, e.g. for the air, correspond to the data shown on the
machine and the operating instructions.
Since feed cup opening and some other operations are realized pneumatically,
a compressed air connection of 6 bar is required (see point “2.4 Technical
data”). Regulation of the pressure by means of compressed air conditioner
293.0975 at the stand.
A T T E N T I O N !
Before putting the machine into service make sure
that the electrical connecting data on the motor’s
name plate, your electric network, and all other connecting
values, e. g. for the air, correspond to the data shown on
the machine and the operating instructions.
All rust preventing agents, such as Vaseline and similar agents, have to be
wiped off carefully, particularly from the most important sewing tools.