42
Necessities:
●
The transmitter
●
The small screwdriver (included in the package)
●
A pencil
●
An impact drill with the correct drill bit
●
The 2 plugs
●
The 2 screws
●
A Phillips screwdriver
●
Safety glasses
●
A vacuum cleaner (for cleaning up all the mess)
Step 1: Determine the correct mounting position
Step 2: Drill the holes
Mea marking the drill position is by far the most important steps. Make sure that the holes you are going to make in the
wall are measured very precisely.
●
Use the small screwdriver to open carefully the backside of the transmitter. Insert the screwdriver into the hole between
the cover and the base of the transmitter. Squeeze the screwdriver in, meanwhile tilt downwards to open the cover.
●
Use the base of the transmitter as a template to mark the position of the drill holes with a pencil.
●
Use an impact drill and a drill bit to drill the hole. Use a masonry drill for a stone wall, and a concrete drill for a concrete
wall.
●
The diameter of the drill bit must have the same diameter as the diameter of the plug.
●
The drilling depth must be equal to the length of the plug + a maximum of 5mm. Do not drill any deeper holes.
●
Use safety glasses when drilling the holes.
●
Hold the drill directly in front of the wall and support the drill with your other hand. Always drill at right angles and never
change direction while drilling.
FOLLOW THE SAFETY INSTRUCTIONS CAREFULLY.
These can be found in the chapter “SAFETY INSTRUCTIONS – Safe Drilling”.
