19
INSTALLING THE REAR WHEEL (cont.)
With the wheel partly inside the frame, thread the chain around the hub sprocket
(Fig. 3-10A)
. Slide the rear axle into the dropouts
so that the non-turn washers (black on right side and gray on left) are on the outer side of the frame just under the chrome hub nuts.
The non-turn washers have a tongue that fits into the dropout slot
(Fig. 3-10B)
to prevent turning. Pull the wheel rearward to make the
chain taut and center the wheel, then tighten the hub nuts using the 15 mm open end wrench
(Fig. 3-10C)
.
Install the shifter cable by inserting a 2 mm hex wrench into the hole on the rear edge shifter cassette pulley at the 9 o’clock position
(Fig. 3-11A)
. Rotate the cassette pulley counter-clockwise by moving the inserted 2 mm hex wrench to the 6 o’clock position
(Fig.
3-11B)
. Insert the shifter cable fixing screw with the hex nut facing outward into the oblong slot on the cassette pulley, now located at
the 9 o’clock position
(Fig. 3-11C)
.
A
B
C
Figure 3-11. Installing the rear wheel (cont.)
