15
ATTACHING THE TWO FRONT WHEELS (cont.)
A
B
C
Figure 3-4. Attaching the two front wheels (cont.)
Figure 3-5. Attaching the two front wheels (cont.)
To attach the left inboard rod end on the aluminum steering linkage to the head tube bracket, remove the nut from the rod end stud
(Fig. 3-4A)
, insert the nut into the slot on the back side of the bracket
(Fig. 3-4B)
, push the rod end stud into the hole to contact the
nut, and screw the stud in tight using the 12 mm open end wrench
(Fig. 3-4C)
.
IMPORTANT:
Make sure the rod end stud on
the aluminum steering linkage is pushed into
the FRONT SIDE of the head tube bracket
hole, with the nut contacting the stud on the
rear side of the head tube bracket hole.
Repeat the procedure to attach the right
front wheel
(Fig. 3-5A)
. When the front
wheels are attached, the front end should
appear as shown
(Fig. 3-5B)
.
A
B
