14
ATTACHING THE TWO FRONT WHEELS
The brake cables are attached to the front wheels. Rest each front wheel against the box
(Fig. 3-3A)
. Remove the king pin bolt
from the left front beam clevis using fingers
(Fig. 3-3B)
or, if tight, the 6 mm hex and 17 mm open end wrenches. Slide the black
steering knuckle attached to the left wheel into the clevis slot and insert the king pin bolt
(Fig. 3-3C)
, then tighten until snug with
the 6 mm and 17 mm wrenches.
IMPORTANT:
Make sure the brake cables are routed over the front beam and under the linkage rods (see Fig. 3-5B).
IMPORTANT:
Make sure that the steering arm of the knuckle extends forward and that the king pin bolt is not too tight to prevent the
knuckle from swiveling on the king pin bolt.
A
B
C
Figure 3-3. Attaching the two front wheels
IMPORTANT:
Make sure the nuts on the outboard rod ends are tight. If a washer is inserted above the nut on the outboard rod end
from the factory, remove this washer and retighten the nut.
