Close and Secure the Drive Tray
With all the drives now fitted to the tray, return it to the original position
and secure it is place with a single screw each side of the tray. Power and
Data cables can now be connected to the drives.
Adjusting the Optical Drive
Adjust the position of the optical drive so its aligned with the inside
front of the case and the eject button protrudes about 1mm out from
the front of the case.
Test that the button operates correctly by listening/feeling for the
button ‘click’ when pressing the eject button.
Once the correct position has been found, tighten the 4 screws to
secure the optical drive in place.
CS-M3 x 6
Replace the Top Panel
With all the components installed, the top panel can now be replaced.
Prior to doing this, ensure that all cables are connected and all
components are securely fitted. Secure the top panel it in place using 4
screws, 2 from either side of the case, between the heatsink fins.
Connect Power & Other Cables
With the case now fully assembled, all that remains is to connect the
power and other cables.
When choosing a suitable place to position your case, please consider an
area with adequate air flow and a moderate room temperature, out of
direct sunlight.
15
CS-M3x5
PH-M3x8
