Stratus U916 E1, Installation Manual

Page: 41 / 76

Netra/Sunfire Systems: U916 PCI Card Installation
3-1
Chapter 3
Netra/Sunfire Systems:
U916 PCI Card Installation
3-
This chapter describes how to locate, install, remove, or replace a U916 T1/E1 PCI
card in a Netra 20/T4 or SunFire V480 series system. It contains the following sections:
•
Netra System: Locating the PCI Card Slots
•
SunFire System: Locating the PCI Card Slots
•
Netra System: Installing a U916 PCI Card
•
SunFire System: Installing a U916 PCI Card
•
Connecting the Cable
•
Removing or Replacing a U916 PCI Card
Netra System: Locating the PCI Card Slots
The PCI cards in a Netra 20/T4 series system are installed in one of three available PCI
card slots accessed from the top of the cabinet (see Figure 3-1). The PCI card slots are
labelled PCI 1, PCI 2, and PCI 3, which appear from left-to-right in Figure 3-1.
Table 3-1 lists which slots (in order) to use depending on the number of U916 PCI cards
you install. (Install cards as indicated in Table 3-1; failure to do so can result in an
instance numbering problem that might prevent proper configuration of the cards.)
Table 3-1. Netra 20/T4 System: PCI Slot Numbering
Cards in the System Slots to Use
1 U916 PCI card PCI 3
2 U916 PCI cards PCI 3, PCI 2
3 U916 PCI cards PCI 3, PCI 2, PCI 1