16
www.strata.co.nz
ADVANCEMIG 200
Care & Maintenance
Keep your Welding Machine
in Top Condition
The ADVANCEMIG 200 does not require any special
maintenance, however the user should take care of
the machine as follows:
• Regularly clean the ventilation slots.
• Keep the casing clean.
• Check all cables before use.
• Check electrode holders, work lead/clamps and
welding torches before use.
• Replace worn electrode holders and earth
clamps, which do not provide a good
connection.
• Replace worn consumable parts in a timely
manner.
• Use a soft cloth or brush to clean electrical
components.
• Do not use liquid cleaning products, water or
especially solvents.
• Do not use compressed air to clean electrical
components as this can force dirt and dust
further into components, causing electrical short
circuits.
• Check for damaged parts. Do not use the welder
with damaged parts.
• A damaged welder must be carefully checked by
a qualified person to determine that it will operate
properly. Check for breakage of parts, mountings
and other conditions that may affect its operation.
An authorised service centre should properly
repair a damaged part. Have your welder repaired
by an expert.
This appliance is manufactured in accordance with
relevant safety standards. Only experts must carry
out repairing of electrical appliances, otherwise
considerable danger for the user may result. Use only
genuine replacement parts. Do not use modified or
non-genuine parts.
Storing the Welder
When not in use the welder should be stored in the
dry and frost-free environment.
WARNING!
Before performing cleaning/main-
tenance, replacing cables / connections , make
sure the welding machine is switched off and
disconnected from the power supply.
