7. Oven burner fan unit
a. It is easier to lift out the fan cover if you
first remove the oven shelf runners:
(i) Pull the bottom edge away from the
oven side.
(ii) Disengage the runners from the
hanging holes.
b. From the inside of the oven, unscrew
the 4 screws which secure the fan
cover to the back of the oven.
c.
Remove 2 screws from electrode
bracket.
d. Remove rear service panel (5).
e. Prevent motor from rotating whilst
unscrewing burner from within oven.
Note:
Left hand thread, turn clock-
wise to unscrew.
8. Micro-computer
a. Gain access to the rear chamber (5)
and disconnect all wire connectors
from PCB.
b. Remove PCB earthing screws found at
the top RH and bottom LH corners.
c.
Ensure the distance tube around the
earthing screws is retained and
replaced when refitting the PCB, as it
will not work without them.
d. The complete board can now be
removed by disconnecting the
insulating stand-offs.
Note:
It is practically impossible to
exchange individual components from
the computer board. A complete new
board should be substituted ensuring
correct software is installed.
9. Door switch
a. Remove appliance from housing (2).
b. Remove top panel and RHS panel.
c.
Unscrew the screws which secure the
door switch and its bracket to the oven
door frame.
10. Cooling fan
a. Remove appliance from housing (2).
b. Gain access to rear compartment (5).
c.
Disconnect the fan leads from the
terminal block.
d. Unscrew the 4 screws which secure
the fan mounting bracket.
e. Remove the 4 screws which secure the
fan to the mounting bracket.
11. Oven light fitting(s)
a. Remove appliance from housing (2).
b. Remove the top and side panels.
c.
Remove the leads from the back of the
light fitting.
d. Squeeze in the metal retaining clips to
release the fitting from the oven side.
12. Grill burner
a. Remove appliance from housing (2).
b. Unscrew the top and rear panel
securing screws.
c.
Remove the top and rear panels.
d. Detach the spring clip at the injector
block.
e. From the top, remove the grill burner
securing screws & lift out the grill
burner complete with cover.
13. Ceramic grill glass
a. Gain access to top compartment (5).
b. Remove the grill burner (12).
c.
Lift up all the tabs which secure the
grill glass.
d. Replace glass and bend tabs down.
14. Grill igniter electrode
a. Remove the grill burner (12).
b. Unclip the electrode wire from the
control board.
Important:
The electrode connection
must be to the correct connector at the
control board.
29
SERVICING INSTRUCTIONS
21258 10 - Q900GRF DO 11/07/2002 10:08 Page 31
