STOVES 900G, User, Installation & Servicing Instructions

Page: 28 / 48

CLEANING
Glass parts
DOOR PANEL
,
FASCIA PANEL
Warning : Do not operate the appliance
without the glass panel correctly fitted.
Do not use abrasive cleaners or
polishes. Use a mild cream cleaner -
eg; “Jif”. Rinse thoroughly and dry
with a soft cloth.
The inner door glass panel can be
removed for cleaning, but it must be
replaced the right way up (so the
reflective side - if fitted - faces inwards)
and pushed fully in to the stop position.
Open the door wide, hold the top and
bottom edges & slide out. When refitting,
take care that the glass is held level
and straight with the grooves in the
door trims before sliding back in.
Stainless Steel surfaces (stainless
steel finish models only)
FACIA PANEL
,
HANDLES
,
DOOR PANELS
Only use a clean cloth wrung out in hot
soapy water, and dry with a soft cloth.
Stubborn marks can be removed using
“Luneta”. We recommend that you
clean the whole of the stainless steel
area to maintain a uniform finish.
Supplies can be purchased from
H.R.P.C.
- contact direct sales
order line on 01772 819 672.
Do not use undiluted bleach or any
products containing chlorides as they
can permanently damage the steel.
Extra care should be taken when
cooking food in salted water. Some
foods are corrosive - eg; vinegar, fruit
juices and especially
salt - they can
mark or damage stainless steel if they
are left on the surface. Turn off and
wipe any spillage immediately, taking
care to avoid skin contact with any hot
surface or spillage.
Sharp objects can mark the surface of
stainless steel, but marks will become
less noticeable with time.
To maintain the finish of the stainless
steel, or to remove any greasy marks,
wipe the stainless steel surface
sparingly with a
minimum amount of
“Johnson’s Baby Oil” and kitchen paper.
Do not use cooking oils, as these may
contain salt, which can damage the
stainless steel surface.
26
23894 02 - Q901G/900G RS2 03/04/2001 14:19 Page 28