Storm UNIQUE 2.1, Operating Manual

Page: 12 / 21

11
5. Operating the Unique 2.1
Fig. 2: Adjusting the fan output Fig. 3: Adjusting the DMX-start address
Fig. 4: Changing to the Profile-Mode Fig. 5: Switching the device off
An outstanding feature is the adjustable output of the Unique 2.1 . The pump and
the fan can be easily and separately adjusted and regulated in 99 steps via buttons.
Any desired effect can be achieved in steps of 1%: from the finest mist to a thick haze,
similar to fog. To achieve the thickest effect the pump must run at 99%, the fan at 1%.
The finest haze can be achieved with lower pump and higher fan settings. The data
can be readjusted whenever you want to.
o ‹ƒwy „Šˆ ‚Š~{ Unique 2.1 externally through the XLR sockets [2 and 3].
Please note : DMX takes priority. That means: when the machine is controlled via DMX
512 this data takes priority over 0-10V (+) DC and Stand alone operation.
Please note Po ‹yw„vŠ~ ‚zz „Š~{c z{Cx‹ŠŠ „| ˆ‰yˆ ‚‚„}Š~ˆ ‹}~Š~{c{„‹D
The Mode-button has to be pressed only momentarily. If the Mode-button is pressed
more than two Seconds, the machine will change into the Timer-Mode (see point
5.4.5).
5.4.1 Operating via DMX 512
Connecting the Unique 2.1 to a DMX desk, use the XLR socket [2] beside the control
panel. As soon as the machine receives a correct DMX signal, the yellow DMX-LED [19]
will be lit.
Please note : The Unique 2.1 uses two channels on your desk! First Channel
= Pump, second Channel =Fan
DMX
IN
ACTIVE
888 ADDRESS
À
088 PUMP
À
&88 FAN
0 PAUSE
MIN À
& FOGTIME
SEC
PAUSE
À
LEVELA
À
LEVELB
TIMER
PROFILE
2 7 5
DMX
IN
ACTIVE
888 ADDRESS
À
088 PUMP
À
&88 FAN
0 PAUSE
MIN À
& FOGTIME
SEC
PAUSE
À
LEVELA
À
LEVELB
TIMER
PROFILE
F 7 5
DMX
IN
ACTIVE
888 ADDRESS
À
088 PUMP
À
&88 FAN
0 PAUSE
MIN À
& FOGTIME
SEC
PAUSE
À
LEVELA
À
LEVELB
TIMER
PROFILE
O F F
DMX
IN
ACTIVE
888 ADDRESS
À
088 PUMP
À
&88 FAN
0 PAUSE
MIN À
& FOGTIME
SEC
PAUSE
À
LEVELA
À
LEVELB
TIMER
PROFILE
P r o