Storm UNIQUE 2.1, Operating Manual

Page: 11 / 21

10
DMX
IN
ACTIVE
888 ADDRESS
À
088 PUMP
À
&88 FAN
0 PAUSE
MIN À
& FOGTIME
SEC
PAUSE
À
LEVELA
À
LEVELB
TIMER
PROFILE
P 1 5
5.4 Control choices
14: Mode-button
15: Up/Down-button 16: Enter-button
17: Led-Display 18: Active-LED, green
19: DMX-LED, yellow
20: Profile/
Timer-LED, red
Fig. 1: Adjusting the pump output
5.3 Switching the device off
5. Operating the Unique 2.1
wD fˆ{‰‰Š~{c z{x‹ŠŠ „qGJsŠ‚‚«e\\¬w††{wˆ‰ „Š~{z‰†‚wD
After 15 Seconds the machine will switch into the post-run-
ƒ z{ w‹Š ƒwŠyw‚‚D e„ Š~{ b[Z z‰†‚w ‚„{‰ w††{wˆ ~y~
move from upper left to the lower right while the heater is
cooling.
To cut this process short, the air pump works with full power for a short time and
also put all remaining fluid out of the vaporizer. The remaining
fluid will maybe come out as a bigger haze cloud. This is normal
and no failure of the machine.
When the heater is cooled down, a red decimal point will ap-
pear on the right bottom edge of the display.
b. When you switch off the DMX signal, the machine will be switched into the post-
run-mode to cool down automatically after 15 Seconds.
Note: Please make sure that the Unique 2 will not be disconnected too early to allow
the fan to run until the device has cooled down. This will ensure that no fluid remains
in the vaporizer to come out as droplets when the device is switched on next time.
.
_
_ _