DR365V-HA Setup Guide
Software Configuration
V8.0.3x
© StoneFly Inc. | All rights reserved
Page 63
Concentrator User’s Guide.
Review the status of all SAN Network Interfaces to select which ports will be used. It is not
necessary to select all available ports. All ports selected must have cables attached to them to
maintain the proper cluster configuration and operation. The
Id
button is used to flash the link
light on a specific port. Select a port by clicking on the box in the
Bond
column. Changes are not
enforced until the next reboot. At first power up a default configuration is presented. Changing
the default settings requires a reboot of the Storage Concentrator. Navigate to the
System >
Admin > General
screen and click on
Reboot
. If no changes are desired continue to the next
step to configure the Management Port.
Click on
Management Port
. The Management Port Settings screen will appear.
DR365V-HA Management Port Settings Screen
Enter the
Default Gateway
setting.
Enter the
IP Address
for the Management port.
Enter the
NetMask
setting for the Management port. It is not necessary to select a Management
Port as on the Local iSCSI Port screen. There is only one port assigned for this purpose.
The
DR365V-HA
automatically configures the Network and Broadcast settings based on the
IP address and Netmask settings. Click on the
Advanced: Network/Broadcast
link to view
or modify the Network and Broadcast settings. For more information refer to “Chapter 2:
Administrative Interface” in the Storage Concentrator
User’s Guide.
Changing the IP address of the Management port will cause your browser to
