DR365V-HA Setup Guide
Initial Introduction
V8.0.3x
© StoneFly Inc. | All rights reserved
Page 14
Installing the Chassis into a Rack
Note:
Keep the ball bearing shuttle locked at the front of the middle rail during installation.
Note:
Figure is for illustrative purposes only. Always install servers to the bottom of a rack first.
Removing the Chassis from the Rack
Caution! It is dangerous for a single person to off-load the heavy chassis from the rack without
assistance. Be sure to have sufficient assistance supporting the chassis when removing it from
the rack. Use a lift.
If necessary, loosen the thumb screws on the front of the chassis that hold it in the rack.
Pull the chassis forward out the front of the rack until it stops.
Press the release latches on each of the inner rails downward simultaneously and continue to pull
the chassis forward and out of the rack.
