11
866-795-1586 • WWW.STONEAGETOOLS.COM
FIGURE 1
ABX-2L AND ABX-2L-V2 MANIFOLD UPGRADE
REMOVING THE ABX-2L AIR MANIFOLD
1. Remove the 4 flat head cap screws from the Top Plate using a 5/32 Allen wrench hex key. Set the Top Plate and screws aside, and open
the Side Door.
(FIGURE 1)
2. Unplug the three tubes from the bottom of the manifold
(FIGURE 2)
and remove the 2 hex head bolts using a 7/16 socket driver or box
wrench. Remove and retain the top 3 JIC fitting assemblies, and disconnect the 3 air tubes from the bottom of the Air Manifold. Discard
the old manifold.
(FIGURE 3)
FIGURE 2
INSTALLING THE AUTOSTROKE AIR MANIFOLD CONVERSION
1. Install the 3 JIC fitting assemblies to the new AutoStroke Air Manifold. Use pipe dope or tape on the NPT tapered threads. Re-attach the
air manifold using the 2 hex head bolts that were reserved from the original manifold assembly.
(FIGURE 1)
2. Reconnect the 3 air tubes (blue, red, and black) to the push-to-connect fittings on the bottom of the air manifold.
(FIGURE 2)
FIGURE 3
FIGURE 2
FIGURE 1
DISCONNECT