Due to continuous product research and development,
the information contained herein is subject to change without notice.
Page 6
www.stoddart.com.au
Specification
On-site Connection:
• The electrical supply must comply with the rating plate data
• Ensure that the machine is connected to a suitably rated and earthed power source
• Ensure that there is an isolation switch installed near the unit
• To connect the power, the unit has a terminal block in the electrical junction box� The power switches and electronic controller are the
face of the electrical junction box
• The equipment should be earthed according to local electrical codes to prevent the possibility of electrical shock� It requires an earthed
receptacle with separate electrical lines, protected by fuses or a circuit breaker of the proper rating
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualifi ed persons in order to avoid a
hazard� Please contact Stoddart for parts and we will advise how to do this in order to avoid any electrical hazard
• The power cable should be dry and/or isolated from moisture or water
Aggregate electrical ratings of the Unit are expressed in kilowatts in this manual�
Single Phase Units:
A terminal block for on-site connection, by a licensed electrician will be supplied inside the service compartment of the unit and be indicated
as:
• 1Ø + N + E
Plug and lead Connection:
• Plug the unit into the applicable power point
Some procedures in this manual require the power to the equipment to be turned
off and isolated. Turn the power OFF at the power point and unplug the power
supply lead by the plug body. If the power point is not readily accessible turn the
equipment off at the isolation switch or the circuit breaker in the switchboard.
Attach a yellow “CAUTION-DO NOT OPERATE” tag. This must be performed
where relevant unless the procedures specify otherwise.
FAILURE TO DO SO MAY RESULT IN ELECTRIC SHOCK.
WARNING
WARNING
This unit must be installed in accordance with AS/NZS 60335.1
Electrical Connection
Information