Stiroplus SP2020, Manual

Page: 16 / 22

finish descaling, restart the appliance and then press the “OK” reset button, the descaling
indicator extinguishes and the appliance can work normally again.
Automatic power off
After enter into the normal standby mode, the appliance will turn off automatically if no any
operation within 10 minutes. To restart the appliance, just need to press the ON/OFF button
again.
Cord clip
When not in use, the steam supply hose and power cord can be stored at the cord clips.
Correct placement of iron on the thermal insulation stand
When the iron is put on the thermal insulation stand, it must be placed on it correctly. See
the Figures as below.
BEFORE FIRST USE
1. Remove any sticker or protective foil from the soleplate.
2. Fill the water tank with water and heat up the iron at the maximum temperature, and then
iron over a piece of damp cloth for several minutes for the purpose of removing any residue
on the soleplate according to the section of “Steam ironing”.
NOTE
：
1) It is normal that strange odor comes out from the unit for the first use. This will cease
after a short while.
2) Some particles may come out of the soleplate when you use the iron for the first time.
This is normal; the particles are harmless and stop coming out of the iron after a short
while.
3) When you activate the “Steam” function, the appliance may produce a pumping sound.
This is normal; the sound tells you that water is pumped into the steam generator.
4) During the heating process of the soleplate, there will be little steam coming out from
the soleplate automatically and this phenomenon will continue for about 3 seconds, This
is normal.
5) There will be little condensation water in the steam supply hose after first use.
But in the second use, the condensation water will be sprayed out together with the
steam at the beginning of releasing steam. This phenomenon will continue for several
seconds. This is normal.