Stiroplus SP2020, Manual

Page: 15 / 22

The default setting is the ECO steam rate when the appliance is turned on. To change to MAX
mode press steam toggle button, the
MAX steam rate indicator will start blinking. When the
MAX steam rate indicator will light solidly, you can start ironing.
Shot of steam
Firstly, select the MAX steam rate by the steam toggle button, and then quickly press the
steam trigger twice within 1 second to produce shot of steam, at that time, the MAX steam
rate indicator will light solidly. After keeping spraying steam for 2.5 seconds, the appliance
will stop working. To exit from the “Shot of steam” mode, just need to press steam trigger or
steam toggle button once.
Steam trigger
When the appliance is heated to the selected temperature and the indicator of selected
steam rate lights solidly, press the steam trigger with a little force, the steam will be sprayed
from the soleplate. When loosen the steam trigger, the appliance can only be used for dry
ironing without steam.
ON/OFF button
Press the ON/OFF button, the appliance enters into working condition, at that time, the
power indicator illuminates in red. To turn off the appliance, hold and press the ON/OFF
button for about 2 seconds.
Steam toggle button / ECO function
The appliance can switch between MAX and ECO steam rates by the steam toggle button.
The default setting is the ECO steam rate when the appliance is turned on. To change to MAX
mode press steam toggle button, the
MAX steam rate indicator will start blinking. When the
MAX steam rate indicator will light solidly, you can start ironing.
Shot of steam
Firstly select the MAX steam rate by the steam toggle button, and then quickly press the
steam trigger twice within 1 second to produce shot of steam, at that time, the MAX steam
rate indicator will light solidly. After keeping spraying steam for 2 seconds, the appliance will
stop working. To exit from the “Shot of steam” mode, just need to press steam trigger or
steam toggle button once.
Refill indicator
If the water in the water tank is lower than the “Min” mark, the refill indicator will illuminate,
following with two beeps, then the appliance will stop working. It prompts that you need to
add water into the tank. At that time, you need to remove the water tank and refill it with
water through the filling aperture, make sure that the water level must be between “Min”
and “Max” mark. Finally, replace the water tank in place, then the refill indicator turns off
and the appliance can work normally again.
Descaling indicator
If the appliance has cumulatively released steam for 100 minutes, the descaling indicator will
illuminate, it means that the steam generator shall be descaled. And you shall perform
descaling by following the operation in Step 3-4 of
“CLEANING AND MAINTENANCE” . After