Stiroplus SP1070, Instructions For Use Manual

Page: 18 / 20

WARNING:
To avoid a risk of scald, make sure the appliance has been cooled down
completely before removing the knob.
4.
After finish cleaning, tighten the knob and restart the appliance, then press the “ OK ” reset
button, the steam generator can work normally again.
5.
When the appliance is not used for a long time, empty the water in the reservoir, turn the
temperature dial to the minimum setting and store the steam supply hose and power cord at
the cord clips, then put the appliance at a place out of the reach of children.
IRONING TIPS
-Always check first whether a label with ironing instructions is attached to the article. Follow
these ironing instructions in any case.
-The iron heats up quicker than cooling it down, therefore, you should start ironing the
articles requiring the lower temperature such as those made of synthetic fiber.
-If the fabric consists of various kinds of fibers, you must always select the lowest ironing
temperature to iron the composition of those fibers.
- Synthetic fibre and silk fabrics should be ironed on their inner side to avoid being shone.
-Velvet and other textures that rapidly become shiny should be ironed in one direction with
light pressure applied. Always keeps the iron moving at any moment.
-Pure wool fabrics (100% wool) may be ironed with the steam iron. Use a dry cloth as a mat
and then select the corresponding fabric setting for ironing.
- Never iron over zip, rivet in the cloth. This will damage the soleplate. Iron around any such
object.
NOTE: When ironing woolen fabrics, shining of the fabric may occur. So it is suggested that
you should turn the article inside out and iron the reverse side.
ADDITIONAL TABLE
Setting Temperature Fabric
The first setting 80<T<120
°
C Silk, acetate,elastane,polypropylene
The second setting 115<T<160
°
C Cupro,polyester,wool
The third setting 170<T<215
°
C Cotton,triacetate, viscose,
Maximum 175<T<225
°
C Flax
Fig.1