Stiroplus SP1070, Instructions For Use Manual

Page: 15 / 20

Press the ON/OFF button, the appliance enters into working condition, at that time, the
power indicator illuminates in red. To turn off the appliance, hold and press the ON/OFF
button for about 2 seconds.
Steam toggle button / ECO function
The appliance can switch between MAX and ECO steam rates by the steam toggle button.
The default setting is the ECO steam rate when the appliance is turned on. To change to MAX
mode press steam toggle button, the MAX steam rate indicator will start blinking. When the
MAX steam rate indicator will light solidly, you can start ironing.
Shot of steam
Firstly select the MAX steam rate by the steam toggle button, and then quickly press the
steam trigger twice within 1 second to produce shot of steam, at that time, the MAX steam
rate indicator will light solidly. After keeping spraying steam for 2.5 seconds, the appliance
will stop working. To exit from the “Shot of steam” mode, just need to press steam trigger or
steam toggle button once.
Refill indicator
If the water tank is lack of water, the refill indicator will illuminate, following with two beeps,
the steam generator stops working. It prompts that you need to add water into the tank. At
that time, you need to remove the water tank and refill it with water through the filling
aperture, then replace the water tank back in position, finally, press the
“ OK ” reset button
once, the refill indicator extinguishes and the steam generator can work normally again.
Descaling indicator
If the appliance has cumulatively released steam for 100 minutes, the descaling indicator will
illuminate, it means that the steam generator shall be descaled. And you shall perform
descaling by following the operation in Step 3-4 of
“ CLEANING AND MAINTENANCE ” .
After finish descaling, restart the appliance and then press the “ OK ” reset button, the
descaling indicator extinguishes and the appliance can work normally again.
Automatic power off
After enter into the normal standby mode, the appliance will turn off automatically if no any
operation within 10 minutes. To restart the appliance, just need to press the ON/OFF button
again.
Cord clip
When not in use, the steam supply hose and power cord can be stored at the cord clips.
Correct placement of iron on the thermal insulation stand
When the iron
is put on the
thermal
insulation
stand, it must
be placed on it
correctly. See
the Figures as
below.
Wrong placement
Correct placement