Stinger HEIGH10
®
Radio Replacement Kit
for 2011-2018 Jeep Wrangler JK
SR-JK11H
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 7
Rev: V1
Date:031021
®
Step 2
Step 3
Step 1
Using two M4x4 screws from the
HEIGH10 box, mount the support
bracket to the top of the radio
module in the location shown.
Align and attach one of metal side
brackets to the right side of the
radio module using two M5 x 10
screws from the HEIGH10 box.
Align and attach the remaining
metal side bracket to the left side
of the radio module using two M5 x
10 screws from the HEIGH10 box.
Part Two: Attaching the Radio Module Mounting Brackets
FRONT arrow should point
towards the Stinger logo.
Step 3
Step 2
Step 1
If the vehicle is equipped with
a factory amplifier, connect the
8-pin connector to the AMPLIFIED
connector. All others connect to the
NON AMPLIFIED 8-pin connector.
Set the dial on the side of the
RP4-CH11 interface to Number 4.
Remove the warning sticker
covering the 16-pin plug on the
end of the interface.
Part Three: Main Harness Connections (RP4-JK07-HAR)
NON-AMPLIFIED
AMPLIFIED
Connect the 16-pin and 4-pin
connectors on the RP4-JK07-HAR
Main Harness to the RP4-CH11
interface module.
Section 3: Display, Radio Module and Harness Preparation (cont.)
