Stinger HEIGH10
®
Radio Replacement Kit
for 2011-2018 Jeep Wrangler JK
SR-JK11H
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 10
Rev: V1
Date:031021
®
Part Three: Attaching the Display Panel
Section 4: Radio Unit Installation (cont.)
Step 3
Step 4
Step 2
Step 1
Apply a piece of removable tape
across the bottom of the radio
opening to protect the vents and
panel when mounting the display.
Align the location ribs on the sides
of the mounting panel to the side
brackets to center the panel side
to side.
Holding the mounting panel at the sides:
1. Position the bottom edge almost touching the air vents.
2. Push the assembly against the dash panel.
3. Slide the assembly up until it snaps in place.
Note: Once the locking clips engage, the panel will stay in place.
Connect the two display cables to
the back of the display.
1
1
3
2
2
Installer Note!
Once the radio display is
connected, and before attaching the
display panel, it is recommended
to power up the radio and check
functionality...
Volume, Balance, Fade
AM/FM Reception
Bluetooth
USB
Apple Carplay
Android Auto
Steering Wheel Controls
Camera(s)
