Stinger HEIGH10
®
Radio Replacement Kit
for 2011-2018 Jeep Wrangler JK
SR-JK11H
© 2021 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
AAMP Global is not affiliated with FCA US LLC. Jeep® is a registered trademark of FCA US LLC. The terms
OEM, Jeep®, Wrangler®, and Gladiator® all terms are used strictly for identification purposes only. It is not
implied that any part listed is a product of, or approved by, Fiat Chrysler Automobiles.
Pacific Accessory Corporation
Page 11
Rev: V1
Date:031021
®
Part Three: Attaching the Display Panel (cont.)
Section 4: Radio Unit Installation (cont.)
Step 6
Step 5
Using a Phillips screwdriver, tighten
the four mount screws on the left
and right sides of the mounting
panel.
Install the front frame by hooking
at the top first, then snapping in
the sides and bottom. Remove
the tape by pulling downward.
Product Updates (Firmware)
Reset / Restoring Interface Factory Settings
You can restore the RadioPRO interface module to factory default settings by pressing and holding the programming button
on the side of the module until the status LED starts blinking red. Once the LED starts blinking red, release the button. You
must release the button while the LED is blinking red in order to perform the reset. This reset will restore all settings to factory
defaults.
Email:
Phone:
866-931-8021
International:
727-592-5991
Technical Support
Firmware Updates (Stinger HEIGH10 )
To update the Stinger radio firmware, refer to the HEIGH10 product page: www.stingerelectronics.com/products/heigh10
Firmware Updates (PAC RadioPRO)
The RP4-CH11 can be updated with new firmware as it becomes available using the PAC-UP interface updater (sold
separately). Please visit www.pac-audio.com/firmware for available updates.
