Still iGo neo CX-20, Supplement Instructions

Page: 73 / 112

Operating the iGo neo
4
Operating the truck in ASSISTANCE mode
2
1
> 2 Sec.
Stopping before a crosswise roadway
When the truck is in
ASSISTANCE
mode,
the truck can proceed across a crosswise
roadway after confirmation using the remote
control.
The truck detects that the rack contour con-
tinues beyond the crosswise roadway, and
will stop automatically before the crosswise
roadway.
– Press the iGo button on the remote control
1 x long (> 2 sec.). The LED signals for
the movement tracking scanner switch to
"movement tracking PAUSED" (1).
– Make sure that the truck can cross the
crosswise roadway safely.
– Press and hold the iGo button (2). The
truck will drive over the crosswise roadway.
Once the truck has passed the crosswise
roadway, release the iGo button. The truck
will stop.
– Press the iGO button 1 x briefly. The
LED signals for the movement tracking
scanner switch to "movement tracking
ACTIVE". The truck again follows the
operator automatically.
If the truck fails to detect a continuation of the
rack contour beyond the crosswise roadway,
the truck will not move off. The truck must then
be driven in
MANUAL
mode to the next rack
contour.
NOTE
The authorised service centre can configure
the value for the minimum width of crosswise
roadways, thereby improving the detection of
crosswise roadways.
50108046085 EN - 08/2017 65