Still iGo neo CX-20, Supplement Instructions

Page: 13 / 112

Foreword
1
Using the iGo neo
cleaned before use in
ASSISTANCE
mode
(see the chapter entitled "Cleaning").
Requirements for pallets and loads
Pallets that are wider than the truck (max.
80 cm) must not be transported in
ASSIS-
TANCE
mode.
The weight and type of load must conform
to the specifications in the original operating
instructions for the series-production truck.
Pallets and loads must not protrude beyond
the lateral dimensions of the truck contour.
The load must not protrude beyond the pallet
in a longitudinal or lateral direction.
The stability of the truck must not be jeopar-
dised by the weight and height of the load,
including when cornering.
The load must be secured so that it cannot fall
from the truck or slip and protrude beyond
the lateral truck contour, including when
cornering. The load must be stacked carefully,
with the centre of gravity as low as possible.
Pallets and loads that do not meet these spec-
ifications may be moved in
ASSISTANCE
mode only if the truck safety devices are ad-
justed in advance by the manufacturer. Ad-
justments of this type must only be performed
by qualified personnel at the manufacturer
who have been trained to complete this work.
Customer-specific configuration by
the authorised service centre
The authorised service centre can configure
ASSISTANCE
mode to suit the specific
application conditions. Amongst other things,
the following parameters can be set:
• Dynamic and maximum speed of the drive
programs
• Duration of the run-on time (robotics sys-
tem) after the truck has been switched off
• Minimum distance to the racking in
AS-
SISTANCE
mode
50108046085 EN - 08/2017 5