![background image](http://html1.mh-extra.com/html/stihl/msa-220-0-t/msa-220-0-t_instruction-manual_1378999046.webp)
WARNING
■ The risk of kickback is increased if you use the
chainsaw with one hand. If kickback occurs,
the saw may be thrown up in the direction of
the operator. The operator can lose control of
the saw and be seriously or fatally injured.
► Do not cut with the upper quadrant of the
bar nose.
► Never support yourself on the limb being
cut.
► Never attempt to hold falling limbs.
The saw may be used with one hand if the fol‐
lowing conditions apply:
–
Two-handed cutting is not possible.
–
The working position means that one hand is
required for support during the cut.
–
The saw can be held firmly with one hand.
–
All parts of your body are clear of the cutting
attachment.
13.3
Sawing
WARNING
■ If kickback occurs, the chainsaw can be
thrown up in the direction of the operator. This
may result in serious or fatal injury to the user.
► Always cut with the chain running at full
speed.
► Do not cut with the upper quadrant of the
guide bar nose.
► Begin the cut with the chain running at full
speed and keep the guide bar vertical.
0000-GXX-3210-A1
► Engage the spiked bumper and use it as a ful‐
crum.
► Guide the full width of the guide bar into the
wood and reposition the spiked bumper as
required.
► Take the weight of the chainsaw at the end of
the cut.
13.4
Limbing
► With the chain running a full speed, pivot the
guide bar downward against the limb.
2
1
0000-GXX-C575-A0
3
A
B
► Make a relieving cut (1) in the compression
side (A) first, then perform a bucking (2) cut at
the tension side (B) from above, directly above
the first cut.
► Make the last cut (3) close to the trunk without
damaging the bark.
13.5
Felling
13.5.1
Basic information on felling cut
A
A
B
B
C
C
0000-GXX-A332-A0
A Felling notch
The felling notch determines the direction of
fall.
B Hinge
The hinge controls the part of the tree being
removed as it drops to the ground. The width
of the hinge is 1/10 of the trunk diameter.
C Felling cut
The tree is felled with the felling cut.
13.5.2
Cutting a felling notch
The felling notch determines the direction that
the part of the tree being removed will fall. Coun‐
try-specific standards for making the felling notch
must be observed.
90°
1
0000094225_001
English
13 Operating the Saw
46
0458-007-9621-B