MS 441 C-M
English
32
N
Use a screwdriver to pry the rope
out of the starter grip.
N
Remove the remaining rope from
the rotor and starter grip.
N
Thread the new rope through the
top of the starter grip.
N
Thread the end of the rope through
the top of the guide bushing (5) and
rope rotor (6) and secure it with a
simple overhand knot.
N
Coat the rope rotor bearing bore
with non-resinous oil.
N
Slip the rotor over the starter
post (7) – turn it back and forth to
engage the anchor loop of the
rewind spring.
N
Fit the pawls (4) in the rotor and fit
the washer (3) on the starter post.
N
Use a screwdriver or suitable pliers
to install the spring clip (2) on the
starter post and engage it on the
pawls' pegs – the spring clip must
point clockwise as shown in the
illustration.
Tension the rewind spring.
N
Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow.
N
Hold the rotor steady. Pull out and
straighten the twisted rope.
N
Let go of the rotor.
N
Release the rope slowly so that it
winds onto the rotor.
The rewind spring may pop out
and uncoil during this operation –
take care to avoid the risk of
injury
.
213BA019 KN
6
7
213BA020 KN
5
4
4
3
2
001BA096 KN
213BA021 KN
