![background image](http://html.mh-extra.com/html/stihl/fs-25-4/fs-25-4_user-manual_1379255029.webp)
Assemble in the reverse
sequence.
- Tighten clamp screws to 2.0 Nm
•
The groove (1) in the slide
control must engage over the ou-
ter edge (2) of the handle mol-
ding.
•
The torsion spring (3) must
engage the recess (4) in the sli-
de control.
- Remove the air filter -
- Take throttle cable off the con-
tact spring -
•
Pull short circuit wire off the
connector tag.
•
Disconnect throttle cable nipple
(1) from slotted pin (2) on throttle
lever.
•
Slacken off nut (1).
•
Pull throttle cable (2) out of hol-
der.
•
Remove short circuit wire (3)
from the throttle cable.
•
On bike handle, take throttle
cable out of retainers.
Assemble in the reverse
sequence.
- Adjust throttle cable -
FS 25-4, 65-4
29