33
BR 500, BR 550, BR 600
– Remove the cam followers,
b
7.4
:
Pull out the pin (1).
:
Remove the cam gear (2).
Install in the reverse sequence.
Coat all parts with two-stroke
engine oil before installing.
:
Rotate the crankshaft until the tip
(arrow) of the flywheel lines up
with the ignition module as
shown.
452RA081
VA
:
Fit the cam gear so that the
marks (2) and (3) and in
alignment with the notches (1)
and (4) in the cylinder.
452RA167
VA
3
2
1
4
:
Install the pin (1).
The marks must not move out of
position while the cam gear is being
fitted.
– Rotate the crankshaft until the
cam lobe on the cam gear points
452RA107
VA
1
downward.
– Install the cam followers,
b
7.4
– Remove cam gear cover,
b
7.3
:
Check free movement and
function of decompression
system lever (arrow).
– Lever must project about 2 mm
from the cam.
VA
249RA140
– Push decompression system
lever counterclockwise. The lever
must move freely and retract fully.
If the lever is difficult to move, worn
or not visible, install a new cam
gear,
b
7.5.
7.5
Cam Gear
7.5.1
Decompression System
RA_452_00_01_02.book Seite 33 Donnerstag, 16. Februar 2012 11:52 11