Stiga MPST 84 Li 48 V1, Operator'S Manual

Page: 140 / 224

EN - 34
PROBLEM Cause Remedy
8. The icons in fig. 13.E and
fig. 13.O remain ON, battery
LEDs 1 and 3 flash.
Pushbutton panel
type “I” and “II”
Pushbutton panel of type
“III”
Cutting means motor
over-temperature
caused by:
Turn off the machine, wait for at least
5 minutes and then restart it.
Work conditions
too demanding.
Reduce forward speed:
Increase the cutting height:
9. The icon in fig. 13.E remains
ON and battery LEDs 1, 3
and 5 flash.
Pushbutton panel
type “I” and “II”
Pushbutton panel of type
“III”
Cutting means motor
stall caused by:
1. Work conditions
too demanding.
Reduce forward speed:
Increase the cutting height:
2. Obstructions that
prevent rotation of
the cutting means.
Remove the obstructions.
3. The cutting
means assembly
is full of grass
Clean the cutting means assembly:
10. The icons in fig. 13.E and
fig. 13.O remain ON, battery
LEDs 1, 2 and 4 flash.
Pushbutton panel
type “I” and “II”
Pushbutton panel of type
“III”
Drive motor over-
temperature caused by.
Switch off the machine and wait for at least 5
minutes before repeating the starting procedure.
1. Drive motor
under stress.
Reduce forward speed:
2. Slope too steep . Reduce speed and check the slope of
the ground where you are working.
3. Excessive mud
on the wheels.
Make sure that the wheels are not
blocked and clean as needed.
11. The icons in fig. 13.E and
fig. 13.O remain ON, battery
LEDs 1, 2, 4 and 5 flash.
Pushbutton panel of type
“I” e “II”
Pushbutton panel of type
“III”
The machine starts
with the drive pedal
not released (not in
neutral position).
Switch off the machine and repeat the starting
procedure only after having checked that the drive
pedal is in the neutral position (pedal released).