Stiga MCS 470 Li 60 series, Operator'S Manual

Page: 128 / 413

EN - 11
Cleaning the transmission 1-2 times a year par. 7.5
Replacing the cutting means - par. 8.1 ***
Drive adjustment *** **
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or a specialised Authorised Service Centre
*** Operation to be performed at the first signs of any malfunction
14. PROBLEM IDENTIFICATION
14.1 FOR MACHINES WITH ELECTRONIC CONTROL
If problems persist after having performed the above operations, contact your dealer.
PROBLEM PROBABLE CAUSE SOLUTION
1. After pressing the
starter button, the LED
does not come ON.
Safety key is not inserted or
is inserted incorrectly.
Insert the key (par. 6.3).
Safety key in “OFF” position. Turn the safety key to "ON" position (par. 6.3).
Battery is not inserted or is
inserted incorrectly.
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.3).
Low battery. Check the battery status and recharge
if necessary (par. 7.2.2).
Incorrect battery combination.
Check if the battery combination is
correct, following the instructions
supplied in the "Technical data" table.
2. After pressing the
starter button, the LED
does not come ON
and the machine sets
off a sound signal.
Internal motor anomaly. Remove the safety key and contact
the Authorised Service Centre for
checks, replacements or repairs.
3. The motor shuts down
whilst working.
Battery is not inserted correctly. Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.3).
Low battery. Check the battery status and recharge
if necessary (par. 7.2.2).
4. The danger LED lights
up (Fig. 24.A) and
the machine emits
an acoustic signal.
Cutting means blocked. Turn the machine off, remove the safety key
and wear work gloves.
Check and eventually remove any obstructions
in the machine lower side (par. 7.3.2) that
prevent rotation of the cutting means.
If the problem continues, contact the
Authorised Service Centre for checks,
replacements or repairs (par. 8.1).
Machine fault Remove the safety key and contact
the Authorised Service Centre for
checks, replacements or repairs.
Drive motor over current for heavy
working conditions (drive under stress).
– Make sure that the wheels are not
blocked. Clean as needed.
– Check the slope of the land you
are working on (par. 6.4.1).
5. The danger LED
lights up (Fig.24.A).
The thermal protection has tripped
due to overheating of the machine.
Wait for at least 5 minutes and
restart the machine.
6. Mowing is difficult. The cutting means is not in good state. Contact the Authorised Service
Centre for the sharpening or
replacement of the cutting means.