Stiga E 300 Li 20 A, Operator'S Manual, Page: 35 / 42

EN - 8
the user’s location, transfer of the machine to the
Dealer, rental of replacement equipment or calling of
independent enterprises to perform maintenance work.
The user is protected by his or her own national legislation.
The user’s rights under the national laws or his or her own
country are not in any way restricted by this warranty.
12. TROUBLESHOOTING
If problems persist after having performed the above operations, contact your dealer or authorised service dealer.
PROBLEM PROBABLE CAUSE SOLUTION
1. The engine does not
start when using the
switch
Safety key is not inserted or is inserted
incorrectly.
Insert the key (Fig. 16.A).
Battery is not inserted or is
inserted incorrectly.
Open the hatch and check that the battery
is fitted in its housing correctly (Fig. 23)
Low battery. Check the battery status and recharge
if necessary (Par. 7.1.2).
Motor start-up is slow. Press and hold the control lever
for 2-3 seconds (Fig. 25).
The thermal protection has tripped
due to overheating of the motor.
Wait for at least 5 minutes, then
restart the machine.
2. The engine is running but
the blade does not rotate
The blade fittings are loose. Immediately turn off the motor
and remove the safety key.
Contact an authorised service dealer for
checks, replacements or repairs (par. 7.3).
3. The motor shuts down
whilst working
Battery is not inserted correctly.
Open the hatch and check that the battery
is fitted in its housing correctly (Fig. 23).
Low battery. Check the battery status and recharge
if necessary (par. 7.1.2).
Obstructions that prevent the
cutting blade rotating
Remove the safety key, put on your work
gloves and remove any grass remains or
debris from the lower part of the machine
and/or the discharge channel.
The thermal protection has tripped
due to overheating of the motor.
Clean the cooling air vents (par. 7.2.3).
Wait for at least 5 minutes, then
restart the machine.
Thermal protection has tripped due to
excessive current absorption caused by:
• Excessive high grass cutting.
• Obstructions that prevent
rotation of the blade.
• Too much grass debris accumulated
in the chassis and discharge channel.
• Set a higher cutting height when the
grass is very tall, then set a lower
height and cut the lawn again .
• Remove the obstructions (par. 7.2.2).
• Clean the machine (par. 7.2.1, 7.2.2, 7.2.3
Wait for at least 5 minutes, then
restart the machine.