Stiga E 300 Li 20 A, Operator'S Manual, Page: 31 / 42

EN - 4
6. Name and address of Manufacturer.
7. Article code.
8. Max. motor operation speed.
9. Weight in kg.
10. Power voltage.
11. Electrical protection rating.
12. Nominal power.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorised service dealer.
IMPORTANT The example of the Declaration of
Conformity is provided on the last pages of the manual.
3.4 SAFETY SIGNS (Fig. 2).
The machine has various symbols on it.
Meaning of symbols:
Warning. Read the instructions
before operating the machine.
Danger! Risk of thrown objects.
Keep all persons away from the
work area whilst working.
Be careful when using the sharp
blade. Do not put hands or feet near
or under the opening of the blade.
The blade continues to turn even
after the motor has been switched off.
Remove the safety key (deactivation
device) before doing maintenance.
Only for electric lawnmowers
powered by mains supply.
Only for electric lawnmowers
powered by mains supply.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised service dealer.
4. ASSEMBLY
The safety regulations to follow are described in
chap. 2. Strictly comply with these instructions to avoid
serious risks or dangers.
For storage and transport purposes, some components of
the machine are not installed in the factory and have to be
assembled after unpacking. Follow the instructions below.
Unpacking and completing the assembly should
be done on a flat and stable surface, with enough
space for moving the machine and its packaging,
always making use of suitable equipment. Do not use
the machine until all the instructions provided in the
“ASSEMBLY” section have been carried out.
Before assembling, make sure the safety key is
not inserted in its housing.
4.1 UNPACKING (Fig.3)
4.2 GRASS CATCHER ASSEMBLY (Fig.4
-
6)
4.3 HANDLE ASSEMBLY (Fig.7
-15
)
5. CONTROLS
5.1 SAFETY KEY (DEACTIVATION DEVICE)
The key (Fig. 16.A) found inside the battery compartment
enables / disables the machine’s electric circuit.
Removing the key, the electric circuit is completely
deactivated to prevent uncontrolled use of the machine.
IMPORTANT Remove the safety key whenever
the machine is unused or left unattended.
5.2 SWITCH COMMAND
The switch control (Fig.17.A, Fig.17.A.1)
starts/stops the engine and at the same time
engages/disengages the cutting blade :
Start-up. To start, press the safety button
(fig. 17.A.1 ) and pull the lever (fig. 17.A).
Blade engagement. When the engine starts,
the cutting blade is also engaged.
Stop. The engine stops automatically
when the lever (Fig. 17.A) is released.
6. USING THE MACHINE
The safety regulations to follow are described in
chap. 2. Strictly comply with these instructions to avoid
serious risks or dangers.
6.1 PRELIMINARY PROCEDURES
Make sure that the safety key is not inserted in its slot.
Place the machine in a stable horizontal
position on the ground;
Carry out this operation when
the cutting blade is stationary.
6.1.1 Checking and recharging the battery (Fig.18)
6.1.2 Preparation for grass cutting and
collection in the grass catcher (Fig.19))