ENGL
IS
H
iNSTallaTiON
PrOFi SElECT modular system
WSP-2-DUO, WSG-2-DUO
| 7
[1.2]
Heating circuit with mixer, electrically controlled |
E1-HKE
incl.
SEHC/SEHCM Control unit operating instructions
Heating circuit with mixer with high efficiency pump including
pipework in the base station
D
00000
74
99
9
The flow temperature is controlled by an injection system using
an electric 3-point actuator and a 2-way straight-through valve.
f
f
Observe the enclosed instructions.
Checking / correcting the heating water flow rate
f
f
Ensure heat supply through the central heat generator.
The flow temperature should have reached the design
value for the network.
f
f
Switch on the pump.
f
f
Perform hydronic balancing of the underfloor heating
circuit at the heating circuit distributor according to the
design engineer's specifications.
f
f
Do not draw off any DHW while testing the heating water
flow rate. Make sure that all thermostatic valves and un-
derfloor heating control valves are fully open.
f
f
after balancing is complete, check the set flow tempera-
ture again.
[2]
Heating circuit without mixer | E2-HKU
Heating circuit connection inclusive of pipework in the base
station for connecting to a heating circuit without mixer, e.g.
radiators.
Shut-off valves and a zone valve for manual adjustment of the
heating circuit are integrated. Optional installation of an actu-
ator on the valve is possible.
D
00000
75
000
[7.1]
Pipework thermal insulation | E7-WDR-1
[7.2]
Pipework thermal insulation | E7-WDR-2
Thermal insulation for the pipework in the apartment module,
made of highly flexible insulation material with high resistance
to water vapour diffusion and low thermal conductivity
Summary of Contents for WSG-2-DUO
Page 26: ...26 WSP 2 DUO WSG 2 DUO NOTES...
