OPERATION
Safety
4
|WPL ICS classic | WPL IKCS classic
www.stiebel-eltron.com
1.3 Other symbols in this documentation
Note
General information is identified by the adjacent symbol.
f
f
Read these texts carefully.
Symbol
Meaning
Material losses
(appliance damage, consequential losses and environmen-
tal pollution)
Appliance disposal
f
f
This symbol indicates that you have to do something. The ac-
tion you need to take is described step by step.
1.4 Units of measurement
Note
All measurements are given in mm unless stated oth-
erwise.
1.5 Standardised output data
Information on determining and interpreting the specified stand-
ardised output data.
1.5.1 EN 14511
The output data specifically mentioned in texts, diagrams and
technical datasheets has been calculated according to the test
conditions of the standard shown in the heading of this section.
However, there is a deviation from this norm in the output data for
air/water inverter heat pumps at source temperatures of > -7 °C,
as this concerns partial load values. The associated percentage
weighting in the partial load range can be found in EN 14825 and
EHPA quality label regulations.
Generally, the test conditions stated above will not fully match the
conditions found at the installation site of the system user.
Depending on the chosen test method and the extent to which
this method differs from the test conditions defined in the first
paragraph of this section, any deviations can be considerable.
Additional factors that have an influence on the test values are the
measuring equipment, the system configuration, the age of the
system and the flow rates.
Confirmation of the specified output data can only be obtained if
the test conducted for this purpose is also performed in accord-
ance with the test conditions defined in the first paragraph of this
section.
2. Safety
2.1 Intended use
The appliance is designed for central heating and cooling within
the application limits provided in the specification.
The appliance is intended for domestic use. It can be used safely
by untrained persons. The appliance can also be used in non-do-
mestic environments, e.g. in small businesses, as long as it is
used in the same way.
Any other use beyond that described shall be deemed inappro-
priate. Observation of these instructions and of the instructions
for any accessories used is also part of the correct use of this
appliance.
2.2 Safety instructions
Observe the following safety instructions and regulations.
- Only qualified contractors are permitted to carry out electri-
cal work and the installation of the heating circuit.
- The qualified contractor is responsible for adherence
to all applicable regulations during installation and
commissioning.
- The appliance should only be operated once it is fully in-
stalled and all safety equipment has been fitted.
- Protect the appliance from dust and dirt during building
work.
!
WARNING Injury
The appliance may be used by children over 8 years of
age and persons with reduced physical, sensory or men-
tal capabilities or a lack of experience and expertise,
provided that they are supervised or they have been
instructed on how to use the appliance safely and have
understood the potential risks. Children must never play
with the appliance. Children must never clean the ap-
pliance or perform user maintenance unless they are
supervised.
!
WARNING Injury
f
f
For safety reasons, only operate the appliance with
the casing closed.
2.3 Test symbols
See type plate on the appliance.
!
