26
| SBP 100 www.stiebel-eltron.com
INSTALLATION
Installation
D
00000
48
22
9
1
1 Mounting panel
f
f
Drill the holes and secure the wall mounting bracket or
mounting panel with screws and rawl plugs. Select fixing
materials in accordance with the wall construction/condition.
9.3 Connector with sensor sleeve
f
f
Screw the connector with sensor sleeve for the return
temperature sensor into the "charging station return opt."
connection (see chapter "Specification / Dimensions and
connections").
9.4 Fitting the quick-action air vent valve
Fit the quick-action air vent valve provided to the "ventilation"
connection (see chapter "Specification / Dimensions and connec-
tions").
10. Installation
10.1 Immersion heater accessory
10.1.1 Standard delivery
- Type plate
- Adhesive fascia
- Fitting PG 11
- Wiring diagram label
- Seal ring
- Safety valve
10.1.2 Fitting the immersion heater
Note
If you would like to retrofit the immersion heater, please
observe the following:
f
f
Drain the cylinder (see chapter "Maintenance /
Draining the appliance")
f
f
Release the pipe fittings and remove the appliance
from the wall.
26
�0
3�
01
�0
34
2
f
f
Remove the lower cover.
26
�0
3�
01
�0
34
1
4
2
1
3
1 Quick-action air vent valve
2 Booster heater
3 Seal ring
4 Drain valve
f
f
Remove the drain valve.
f
f
Remove the flange plate. To do this, undo the 10 screws.
f
f
Fit the immersion heater with the seal ring supplied.
f
f
Connect the insulating plate.
