INSTALLATION
Montage
D
EU
TS
CH
www.stiebel-eltron.com
LWE 40 |
15
5.2.5 Bedieneinheit an die Steuereinheit anschließen
1
2
3
4
1
2
3
4
1
2
3
4
D
00000
71
09
4
1
2
1 Rückseite der Bedieneinheit
2 Adapterplatine
5.3 Bedieneinheit montieren
Hinweis
Bevor Sie die Bedieneinheit montieren, muss die Ver-
drahtung zwischen Steuereinheit und Lüfter sowie
zwischen Steuereinheit und Spannungsquelle fertig-
gestellt sein.
D
00000
700
78
f
f
Führen Sie die Adapterplatine durch den Abdeckrahmen und
den Blechrahmen. Die kleinen Laschen zeigen später in die
Wand hinein.
f
f
Stecken Sie die Adapterplatine so auf die Steuereinheit, dass
die Anschlussklemmleisten nicht verdeckt werden.
Hinweis
Das vorhandene Kabel zwischen Adapterplatine und Be-
dieneinheit darf nicht verlängert werden.
f
f
Schrauben Sie den Blechrahmen an die Unterputzdose. Die
Laschen müssen nach oben und unten gerichtet sein.
f
f
Positionieren Sie den Abdeckrahmen auf dem Blechrahmen.
f
f
Setzen Sie die Bedieneinheit in die Öffnung des Abdeckrah-
mens. Drücken Sie die Bedieneinheit vorsichtig an, bis sie im
Blechrahmen einrastet.
5.4 Lüftereinheit montieren
D
00000
700
39
f
f
Entfernen Sie die Stützelemente aus dem
Wandeinbaugehäuse.
f
f
Reinigen Sie das Wandeinbaugehäuse.
D
00000
700
52
f
f
Schieben Sie die Lüftereinheit so in das Wandeinbaugehäuse,
dass der Bügel an der Innenseite und unten ist.
f
f
Achten Sie darauf, dass die Lüftereinheit nicht verkantet und
nicht am Wandeinbaugehäuse hängen bleibt.
f
f
Schieben Sie die Lüftereinheit bis zum Anschlag in das
Wandeinbaugehäuse.