8
GB
O R I G I N A L I N S T R U C T I O N S
PRODUCT CHARACTERISTICS
The battery workshop lamp is a portable light source. Power supply by replaceable battery of high capacity provides
long operation time. High illumination LED diode provides an intensive light stream. Correct, reliable and safe opera-
tion of this power tool depends on proper operation, therefore:
Before starting the work with this tool, please read this manual and keep it properly.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recom-
mendations specified in this manual.
EQUIPMENT
The device is delivered complete and does not require assembly, a battery and battery charger are supplied with
the product.
TECHNICAL PARAMETERS
Parameter
Measuring unit
Value
Catalogue number
78118
Operating voltage
[V]
10,8 DC
Light stream
[lm]
100
Power of light source
[W]
3
Protection class
IP20
Insulation class
III.
Weight
[kg]
0.2
Battery type
Li-ION
Battery capacity
[mAh]
1300
Charger
Input voltage:
[V]
~230
Mains frequency
[Hz]
50
Output voltage:
[V]
13,5 DC
Output current:
[mA]
400
Charging time
[h]
3 - 5
GENERAL SAFETY CONDITIONS
Do not expose the product to temperatures which are too high or too low. The optimum ambient temperature at the
place of operation is from 0 to 40 degrees centigrade.
This is not a waterproof product. Do not immerse the product in water or any other liquid. Do not expose the product
to contact with moisture or atmospheric precipitations. The product is not adapted to indoor use.
Do not illuminate the surface from too short distance. The minimum distance between the head of lamp’s reflector
and illuminated surface is 10 cm.
If the transparent surface of lamp reflector’s cover is damaged, it should be replaced with the one free from any
damages prior to start of work.
Do not direct the light stream directly into the eyes.
PREPARATION TO WORK
Safety recommendations for battery loading
Attention!
Before loading may start make sure the body of the charger, the cable and the plug are not broken or
damaged. It is prohibited to use a damaged loading dock and charger! For the purpose of loading batteries only the
charging dock and the charger provided may be used. Using another charger may be a cause of fire or damage the
tool. Batteries may be charged only in a dry room, protected from unauthorised persons, particularly children. Do not
use the charging dock and the charger without permanent supervision of an adult! If it is necessary to leave the room
where loading is taking place, it is required to disconnect the charger from the mains, removing the charger from
the mains socket. In case when smoke comes out of the charger, or a strange smell is emitted, etc., it is required to
immediately remove the plug of the charger from the mains socket!
