The factory has secured the screen and camera pod for transportation.
Follow the "First time activation" instructions to ensure any packing products
and/or system lockdown brackets are completely removed when the door is
first opened, before deployment of the screen and camera pod.
First time activation
1. Open the door to approximately 90 degrees and press "Stop."
2. At this time it is imperative that you remove any screen lockdown
brackets and/or foam retention blocks. Do not allow the unit to
cycle further until you remove all shipping protection materials.
3. Press "Down," the door kicks back slightly and the projection
screen deploys. The first time you operate the screen, the
protective paper falls out as the screen unrolls. Once the screen
is fully deployed, make sure that no packing paper remains on the
screenroll. The screen can be damaged if loose paper or shipping
materials remain.
4. When the screen reaches its fully deployed position, the camera
pod automatically deploys. This system is electrically sequenced
so you do not have individual control of the motors.
General operation
To lower the screen and camera pod, press the Down button. The door
opens, the screen lowers, and then the camera pod lowers. If you want to
use the screen without the camera pod, press the Stop button after the
screen deploys, but before the camera pod lowers.
To retract the screen and camera pod, press the Up button. The camera
pod raises, followed by the screen. Finally the door closes.
When you lower or retract the screen, it will stop at its factory preset limit. If
an obstacle (such as a person or furniture) gets in the path of the screen as
it is lowered, you should use the switch control to stop the screen's motion;
it will not automatically stop if it hits an obstacle.
In general, when the screen is not in use, store it in the fully retracted
position.
8
Stewart Filmscreen Corporation
O
PERATING THE
S
CREEN
Caution
Stop the door before
the screen deploys.
Caution
Do not operate the motor(s) when any of the following
occurs:
The unit emits any smoke, heat, abnormal noise or
unusual electrical type odor.
The unit is damaged in some way, such as damage
from a water leak.
Obstructions are permitting correct deployment of
door, screen or camera pod.
If any of these situations occur, remove obstructions and /
or call a qualified service person if required.
