Final Assembly (continued)
6.
Feed the rudder (servo nearest the antenna) pushrod, through the hole on the
left
side of former F5
marked R. Pass the elevator pushrod through the
center
hole marked E.
7.
After the pushrods pass through F5, cross them over each other. Feed the rudder pushrod through
the hole on the
righ
t side of F10, and the elevator pushrod through the hole on the
left
side.
8.
Slit the covering over the exit slots on both sides of the fuselage. Pass the rudder pushrod through the
slot in the
right
fuselage side, and the elevator through the slot on the
left
side.
9.
Mount the receiver (PKZ3352) to the receiver tray by first fitting the
rear
edge of the board into the
notch in the short arm of the nylon clip, then press down on the front edge of the brick until it snaps
under the long arm on the front of the clip.
10.
Electric Motor Installation.
Remove the spikes on the bottom of the motor (PKZ3624)
mounting plate, and the bulges on top of the tabs, and sand smooth. Feed the motor lead through
the Engine Detail, former F6, former F3, and down within the radio compartment
below
F1. Press
the motor into the opening in the Engine Detail until it is firmly seated in the mounting slot. When
properly installed, the large gear on the gearbox will be about 1/8 in. in front of the front face of the
faux motor.
11.
Connect the motor lead to the socket located at the
center-rear
of the receiver (PKZ3352), oriented so
that the black wire is nearest the
center
of the circuit board.
Build Instructions
T
oonScale
TM
1911 1/2 Nieuport UM - Build Ins
tr
uc
ti
ons © 2015 S
te
vens AeroModel, a
ll
rights reserved.
Page 26
□
□
□
□
□
□
