Fuselage Construction Cont.
Control Stick:
Cut 1/8 in. dowel to 1/2 in. to
make control stick. Cut 1/8 in heat shrink
tubing to 3/8 in. for grip.
Slide tube onto dowel and secure with thin
CA.
Mount control stick centered on right axle,
tilted forward about 30 degrees.
Strut Assebly
Strut Wire Fittings:
Refer to Strut Assembly
on plan. Using 1/32 wire, make a 90 degree
bend 3/16 in. from one end. Trim wire to 1 in.
length. Repeat to make four fittings.
Using 1/32 in. wire and round nose pliers,
form a loop about 1/8 in. diameter 1-1/2 in.
from one end
Ends of wire should diverge about 45
degrees. Refer to plan for proper angle. Trim
straight portions to 1 in. length.
eHopper
TM
© 2009 Stevens AeroModel all rights reserved.
Page 23 of 36
