4
5
ENGLISH
ENGLISH
Components
Technical Data
Max. viscosity
50 DIN-s
Votalge
220-240V ~ 50Hz
Power
400W
Double insulation
Max. air volume flow
700 L/min
Weight
1.45Kg
Setup
1. Turn both knobs on both sides of
the Air Compressor Assembly to the
“Unlock” position, and Insert the spray
gun into the Air Compressor Assembly
into place,
2. Turn both knobs on both sides of
the Air Compressor Assembly to the
“Lock” position to lock the two pieces
into place.
Aligning the Suction Tube
If you are going to be spraying in a downward direction, the angled end of the suction tube should
be pointing toward the front of the gun.(Fig.A)
If you are going to be spraying in an upward direction,the angled end of the suction tube should be
pointing toward the rear of the gun.(Fig.B)
By pointing the suction tube in the proper direction, you will not have to refill the container as often..
Material Preparation
Before spraying, the material being used may need to be thinned with
the proper solvent as specified by the material manufacturer. Never
exceed the thinning advice given by the coating manufacturer.
Do not use materials with a flashpoint below 70°F (21°C). Follow the
instructions below.
1. Stir the spraying material thoroughly before measuring viscosity.
2. Dip the viscosity test cup completely into the spraying material.
3. Hold the test cup up and measure the time in seconds until the
liquid empties out. This time is referred to below as
Runout Time
Thinning Chart
Material
Runout Time
1) Oil enamel
25-40
2) Oil based primer
30-45
3) Oil stain
No thinning required
4) Clear sealer
No thinning required
5) Polyurethane
No thinning required
6) Varnish
20-50
Material to be sprayed should always be strained to remove any impurities in the paint which
may enter and clog the system. Impurities in the paint will give poor performance and a poor
finish.
MATERIAL FLASH POINT MUST BE 70°F (21°C) OR HIGHER.
Nut
Air cap Nozzle Seal
Trigger
Material
adjustment
knob
container
Filter
housing
Air Compressor
Assembly
Handle
Viscosity cup
A
B