10
FAUCET INSTALLATION
D28 BOX
Step 1 – Installing the faucet
1. Shut off the water supply
2. Cut an adequate opening in the wall for the dimensions
of the D28 box, the corrugated tube, the rigid pipe and
the D28 base (where you want to install the spout).
3. Insert the D28 box to the opening that was cut in the
wall. Connect the water supply pipe to the nipple at the
bottom of the D28 box.
4. Mount the D28 base to the opening cut in the wall and make sure that the
spout is at a 90 degree angle with the wall.
Important:
The D28 base should be installed so that the outside surface of the
finished wall falls between the minimum and maximum lines marked at the base.
5. Assemble the rigid pipe (not supplied) from the nipple at the box to the inlet
at the D28 base.
6. Assemble the corrugated tube between the D28 base and the box, and lead
the connectors through the D28 base and through the D28
box.
6. Assemble the temporary protective cover panel to the
D28 box.
7. Assemble the temporary protective D28 base cover.
(See FIG.4)
8. Once the works on electricity, plumbing and tiles have
been finished, insert the wall rosette through the D28 base.
9. Cut the temporary D28 base cover.
10. Connect the electronic unit connector coming from the
corrugated tube to the solenoid valve connector at the D28
box.
11. If your model is D28 Box E, connect the power supply
connector coming from the corrugated tube at the D28
base to the transformer. (See FIG.5)
12. Connect the solenoid valve cable and the power supply cable at the spout
to those at the D28 base.
13. Fix the D28 spout by inserting the nipple into the D28 base. Make sure that
this area is clean before proceeding. Secure the screw with the Allen key.
