STEP 4 --
Regeneration Hour:
The manufacturer has factory set 2:00 a.m. as the default.
This is the hour of day for regeneration and can be reset by using or
buttons. "AM/PM" toggles after 12. The default time is 2:00 a.m. (recommended
for a normal household).
Press
NEXT
to go to step 5. Press
REGEN
if you need to return to the previous step.
STEP 5 --
Regeneration Minutes:
Set the minutes using or buttons. Press
NEXT
to
exit Installer Settings. Press REGEN if you need to return to the previous step. To
initiate a manual regeneration immediately, press and hold the
REGEN
button for
three seconds. The system will begin to regenerate immediately. The control may
be manually stepped through the regeneration cycles by pressing
REGEN.
Time of day should only need to be set after extended power outages or when daylight saving time
begins or ends. If an extended power outage occurs, the time of day will flash on and off indicating
that the time should be reset.
STEP 1 --
Press SET CLOCK.
STEP 2 --
Current Time (hour): Set the hour of the day using or buttons. AM/PM
toggles after 12. Press
NEXT
to go to step 3.
STEP 3 --
Current Time (minutes): Set the minutes using or buttons. If it is desired
to go back up to the previous step press
REGEN
button once. Press
NEXT
to exit Set Clock.
2. Programming cont'd:
PROGRAMMING PROCEDURES FOR BACKWASHING FILTERS:
1. Set time of day:
4
1
5
2
3
8
