Steris Harmony LED Wall Control Unit, Operator'S Manual

Page: 12 / 74

1-2
10083002 Operator Manual Safety Precautions
Monitor spring arms must be locked (using built-in safety pin) prior to installing and/or removing the
monitor and/or monitor yoke.
WARNING – POSSIBLE PATIENT INJURY HAZARD:
Failure to engage the lighthandle cover completely may result in cover falling from lighthead during the
procedure.
WARNING – BIOHAZARD:
Sterile disposable covers are intended for single use only.
Universal disposal precautions must be observed when disposing of any single use disposable item.
WARNING – PERSONAL INJURY HAZARD:
When fiber optic video accessories are installed to the HarmonyAIR Surgical Lighting System, do not
operate system unless optical fiber cables are fully connected.
To maintain Hazard Levels (1M or less) and safety measures established by STERIS, end user must
assure that any laser device integrated into the system and supplied by sources other than STERIS does
not exceed the optical radiation power (per wavelength) of corresponding STERIS transmitters listed in
Table 1-1. It is the responsibility of the end user to ensure any device not supplied by STERIS
corresponds to the values listed in Table 1-1.
Do not attempt to clean lighthead unless power is turned off and the lighthead has cooled sufficiently.
Do not attempt to adjust suspension system. Refer servicing to qualified service personnel.
Avoid looking directly at into illuminated lighthead. Looking directly into high-intensity light may result in
eye injuries.
Do not attempt to replace LED modules on HarmonyAIR M Series lights. Refer servicing to qualified
service personnel.
WARNING – IMPACT HAZARD: (CONTINUED)
!
!
!
!
!
!
Table 1-1. System Laser Components
Type of Laser
Source
Max. Output
/ Channel
Channels
Wavelength
Notes
(dBm) (mW) (nm)
SDI Transmitter +7dBm 5.01 1 1310
Sources of radiation - self-
contained,
Class 1 Laser
Products
S-Video Transmitter 0dBm 1.0 1 1310
VGA Transmitter +3dBm 2.0 3 1310
DVI Transmitter -3.6dBm 0.44 4 850
!
!
!
!