Steris Harmony LED Wall Control Unit, Operator'S Manual

Page: 11 / 74

1-1
Safety Precautions Operator Manual 10083002
1
The following Safety Precautions must be observed when operating or servicing this HarmonyAIR™ Surgical
Lighting System M Series with Harmony
®
LED Wall Control Unit. WARNING indicates the potential for personal
injury and CAUTION indicates the potential for damage to equipment. For emphasis, certain Safety Precautions
are repeated throughout the manual. It is important to review all Safety Precautions before operating or servicing
the unit.
Strictly following these Safety Precautions enhances your ability to safely and effectively use the unit and helps to
avoid improper maintenance methods which may damage the unit or render it unsafe. It is important to
understand that these
Safety Precautions are not exhaustive; Customers are encouraged to develop their own
safety policies and procedures to enhance and complement these Safety Precautions.
NOTICE: This product contains a Class I laser product: No known biological hazard. The light is shielded from
any possible viewing by a person and the laser system is enclosed and requires a tool to access Fiber Optic
connections.
WARNING – POTENTIAL ENVIRONMENTAL HAZARD:
WARNING – EXPLOSION HAZARD:
Do not use lighting fixture in the presence of flammable anesthetics.
This product contains materials which may require disposal through appropriately licensed and permitted
hazardous waste management firms.
WARNING – ELECTRIC SHOCK HAZARD:
Do not remove covers or perform service other than as described in S
ECTION
8, M
AINTENANCE
of this
operator manual. Refer servicing to qualified service personnel. (M
AINTENANCE
M
ANUAL
, P764330-226
Harmony LA/LED and P764335-782 HarmonyAIR M Series.)
Do not remove control center covers. Servicing must be performed by qualified service personnel.
Avoid possibility of electric shock, and refer any servicing of the ambient light fixture to qualified service
personnel. Ambient light fixture operates using 12 Vdc power from lighthead 24 Vdc power supply.
WARNING – PINCHING HAZARD:
Pinch points are created during extreme articulation of the suspension system. Do not place hands on or
near the suspension knuckle during lighthead articulations and in the area around the monitor yoke
mechanism cover.
WARNING – IMPACT HAZARD:
Do not remove tension screw from the lighthead spring arm joint until the lighthead has been securely
installed onto the spring arm. Note: This warning applies at both installation and removal procedures.
!
!
!
!
!
!
!
SAFETY PRECAUTIONS
1