7-5
Troubleshooting
Operator Manual
122997-341
Table 7-2. Operator Troubleshooting Chart - Alarm and/or Printout
PROBLEM
POSSIBLE CAUSE AND/OR CORRECTION
1.
Display shows:
STOP BUTTON PRESSED!
PUSH START TO RESUME
... and printer prints:
ALARM: HH:SS:MM
STOP BUTTON PRESSED!
STOP/RESET touch pad pressed – press
CYCLE/START
touch
pad to resume cycle operation, or press
STOP/RESET
touch pad
again to abort cycle operation.
2.
Display shows:
LOAD DOOR
OPEN WHEN PROCESSING
... and printer prints:
ALARM HH:MM:SS
LOAD DOOR
OPEN WHILE PROCESSING
1.
Load-side door open – close and latch door. Press
CYCLE/
START
touch pad to resume cycle operation.
2.
If condition reoccurs, call Service.*
3.
Display shows:
UNLOAD DOOR
OPEN WHEN PROCESSING
... and printer prints:
ALARM HH:MM:SS
UNLOAD DOOR
OPEN WHILE PROCESSING
1.
Unload-side door open – close and latch door. Press
CYCLE/
START
touch pad to resume cycle operation.
2.
If condition reoccurs, call Service.*
4.
Display shows:
SUMP
TOO LONG IN FILL
... and printer prints:
ALARM HH:MM:SS
SUMP
TOO LONG IN FILL
1.
Supply valves not fully open – open building and washer supply
valves.
2.
Foam in chamber – rinse chamber with cold water and decrease
detergent injection rate.
3.
If situation reoccurs, call Service.*
5.
Display shows:
SUMP
TOO LONG IN DRAIN
... and printer prints:
ALARM HH:MM:SS
SUMP
TOO LONG IN DRAIN
1.
Self-cleaning screen clogged – remove debris from screen.
2.
If situation reoccurs, call Service.*
* Service Charges may be incurred. Consult your warranty for details.