Stentorfield Contour, Operator'S Manual

Page: 23 / 40

21
Operator’s Manual
Function Switches
Profile and Contour
®
machines are fitted with 3,
two position rocker switches, mounted in a panel
inside the top of the door.
These switches are used for the following functions:
Program Entry Switch
This switch allows the operator to access the
operator’s program. Once pressed, enter the
Operator’s Access Code (selection button 1
followed by 7) from the keypad.
Paper Feed Switch (Freshbrew Models)
This switch allows the operator to feed a new paper roll through the coffee brewer.
When the switch is pressed and released, the brewer will index to its fully open position
and stop.The operator can then safely feed the filter paper through the brewer’s paper
feed mechanism. Pressing and releasing the paper feed switch again will cause the filter
paper to index automatically and the brewer chamber will return to its closed position.
Flush Switch
1. The Flush sequence operates automatically and flushes the complete water
system. Before the sequence begins, the system waits until the water is at the
correct temperature determined by the thermostat. During the entire sequence,
the LCD displays the message:
2. In order to guarantee the highest standards of cleanliness, the boiler fill valve is
disabled, ensuring that the water used in the sequence is delivered at the optimum
temperature to kill any micro-organisms. Each hot water valve and the
corresponding whipper is switched on in sequence for a pre-set flush time.
3. Once the flush cycle is complete, the boiler refills and when the water is at the
correct temperature, the machine returns to standby mode, ready to vend.
4. To flush the machine:
Caution: Ensure that the waste tray is empty (and in place) and keep hands away
from the dispensing area whilst the flushing cycle is in operation.
SORRY NOT IN USE
SELF CLEANING