Stenograph elan Cybra, User Manual

Page: 34 / 68

élan Cybra User Guide
34
Reading Steno Notes
You can read steno notes into your CAT software via USB cable or
serial realtime cable. Steno notes on the élan Cybra are written into
one file in the memory; File.001. If you have multiple lessons to
separate, use a steno break feature such as writing a stroke five or
more times to separate files. Your CAT software must be able to
recognize the steno break for this to indicate separate files when
reading.
USB
To use a USB cable for reading steno notes, you must be using USB
compatible software, such as Case CATalyst V4.0 or higher; have
CAT software that supports the reading of steno notes from a
Stentura; and have installed the élan Cybra USB driver on your
computer. See the
Installing the USB Driver appendix for
instructions on loading the driver.
To read steno notes via USB cable:
1. Turn your élan Cybra Off to close the open file and save the last
steno written.
2. Turn your computer and élan Cybra On . Allow your computer
to boot completely.
3. Connect the appropriate end of the USB cable to the back of the
writer and the other end to a USB port on the computer.
4. Start your transcription software and open your Read program.
Refer to your CAT software manual for instructions on reading
steno notes.
In Case CATalyst, select the following Read options:
a. Device - élan
b. Method - USB
c. Drive: RAM