STEIN300 SoftMove_Stop Devices_08_GB.doc / 10.2018
17
7
Installing the stop devices
The following installation description relates to the installation
•
of the stop device and
•
The stop device with centring rails.
The stop device and the centring rails are mounted directly inside on the belt profile of
the belt element.
7.1
Procedure
The installation procedure can be divided into 5 phases:
Preparation,
Installing the stop device/centring rails/ and sensors,
Connecting the stop device and sensors to the electrical power supply,
Connecting the stop device to the compressed air supply,
Fitting the safety equipment (covers).
i
Please observe the design and measurements of the standard stop situation (stop posi-
tion) (see Chapter 5.1).
WARNING
On operating stations which generate shavings (for example drilling or thread-cutting
machinery), covers should be installed to avoid shavings or cooling fluid coming into
contact with the belt elements or the stop device.
i
Further information is available from STEIN Automation.
7.2
Preparation
DANGER!
From the Workpiece Transport System starting unexpectedly.
DANGER!
HIGH ELECTRICAL VOLTAGE
Electric shock hazard
1 Before carrying out any installation or repair work, disconnect the relevant Work-
piece Transport System from its electrical power supply.
2 Disconnect the workpiece transport system from its compressed air supply
3 Put up warning signs to prevent the system being started up while installation and
repair work is being done.
4 Remove the pallets from the relevant belt element.
